Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 20

JUNOSe 11.0.x BGP and MPLS Configuration Guide
Chapter 8
Part 4
Chapter 9
xx
Table of Contents
Configuring S-VLAN Tunnels for Layer 2 Services ........................................526
Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces .........527
Configuring Local ATM Cross-Connects with AAL5 Encapsulation ...............528
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation .........530
Configuring HDLC Layer 2 Services .............................................................532
Configuring Local Cross-Connects for HDLC Layer 2 Services ...............533
Configuring CE-Side Load Balancing for Martini Layer 2 Transport ..............534
Configuring Many Shim Interfaces with the Same Peer, VC Type, and
VC ID ..............................................................................................534
Configuring Load-Balancing Groups ......................................................536
MPLS Interfaces and Labels ............................................................537
Configuring Load-Balancing Groups ................................................537
Adding a Member Interface to a Group Circuit ...............................537
Removing Member Subinterfaces from a Circuit ............................537
Frame Relay over MPLS Configuration Example ..........................................538
MPLS L2VPN Tunnel over VLAN over LAG Configuration Example ..............541
Configuration on CE1 (Local CE Router) ................................................542
Configuration on PE1 (Local PE Router) ................................................542
Configuration on PE2 (Remote PE Router) ............................................543
Configuration on CE2 (Remote CE Router) ............................................544
MPLS L2VPN Tunnel over LAG Configuration Example ................................545
Configuration on CE1 (Local CE Router) ................................................546
Configuration on PE1 (Local PE Router) ................................................546
Configuration on PE2 (Remote PE Router) ............................................547
Configuration on CE2 (Remote CE Router) ............................................548
Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport
Examples ..............................................................................................548
S-VLAN Subinterface with an Untagged C-VLAN ID Examples .....................551
Multiple ATM Virtual Circuits over a Single Pseudowire Example ................554
Monitoring Layer 2 Services over MPLS
Setting Baselines for Layer 2 Services over MPLS Statistics .........................557
Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over
MPLS ....................................................................................................558
Monitoring ATM Subinterfaces for Layer 2 Services over MPLS ...................558
Monitoring ATM Cross-Connects for Layer 2 Services over MPLS ................560
Monitoring MPLS Forwarding for Layer 2 Services over MPLS .....................561
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS ...........562
Virtual Private LAN Service
VPLS Overview
VPLS Overview ............................................................................................569
VPLS Components .......................................................................................570
VPLS Domains ......................................................................................570
Customer Edge Devices ........................................................................571
557
569