Redistributing Routes From Bgp - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

Software for e series routing platforms bgp and mpls configuration guide
Table of Contents

Advertisement

JUNOSe 11.0.x BGP and MPLS Configuration Guide
disable-dynamic-redistribute
redistribute

Redistributing Routes from BGP

If you have redistributed routes from BGP into an IGP, by default only EBGP routes
are redistributed. You can issue the bgp redistribute-internal command followed
by clearing all BGP sessions to permit the redistribution of IBGP routes in addition
to EBGP routes.
54
Advertising Routes
Use to halt the dynamic redistribution of routes that are initiated by changes to
a route map.
Dynamic redistribution is enabled by default.
This command takes effect immediately.
Example
host1(config-router)#disable-dynamic-redistribute
Use the no version to reenable dynamic redistribution.
See disable-dynamic-redistribute.
Use to redistribute static routes and routes from other protocols into BGP.
Specify the source protocol from which routes are being redistributed with one
of the following keywords: isis, ospf, static, or connected. Use the static keyword
to redistribute IP static routes. Use the connected keyword to redistribute routes
that are established automatically by virtue of having enabled IP on an interface.
You can specify a route map to filter the redistribution of routes from the source
routing protocol into BGP. If you do not specify the route-map option, all routes
are redistributed.
Use the metric keyword to set the multiexit discriminator (MED) for routes
redistributed into BGP. The default MED is the value of the IGP metric for the
redistributed route.
Use the weight keyword to set the weight for routes redistributed into BGP in
the range 0–65535. The default weight is 32768.
You can specify the type(s) of OSPF routes to redistribute into BGP: internal
routes (ospf match internal), external routes of metric type 1 (ospf match
external 1), or external routes of metric type 2 (ospf match external 2).
This command takes effect immediately.
Use the no version to end the redistribution of routes into BGP.
See redistribute.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose

Table of Contents