Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 663

Software for e series routing platforms bgp and mpls configuration guide
Table of Contents

Advertisement

4 routes (264 bytes)
4 destinations (288 bytes) of which 4 have a route
0 routes selected for route tables installation
0 unicast/multicast routes selected for route table installation
0 unicast/multicast tunnel-usable routes selected for route table installation
0 tunnel-only routes selected for tunnel-route table installation
4 path attribute entries (608 bytes)
Local-RIB version 11. FIB version 11.
Status codes: > best, * invalid, s suppressed, d dampened, r rejected,
a auto-summarized
Prefix
> 1:1
> 1:1
> 2:1
> 2:1
To display summary information for the L2VPN address family:
host1#show ip bgp l2vpn all summary
Display summary information for the l2vpn address-family
Local router ID 1.1.1.1, local AS 100
Neighbor
2.2.2.2
To display information for the route that matches the specified prefix (2:1) for a VPLS
instance named customer1 in the VPLS address family:
Peer
Next-hop
0.0.0.0
self
0.0.0.0
self
2.2.2.2
2.2.2.2
2.2.2.2
2.2.2.2
Administrative state is Start
BGP Operational state is Up
Shutdown in overload state is disabled
Default local preference is 100
IGP synchronization is enabled
Default originate is disabled
Always compare MED is disabled
Compare MED within confederation is disabled
Advertise inactive routes is disabled
Advertise best external route to internal peers is disabled
Enforce first AS is disabled
Missing MED as worst is disabled
Route flap dampening is disabled
Log neighbor changes is disabled
Fast External Fallover is disabled
No maximum received AS-path length
BGP administrative distances are 20 (ext), 200 (int), and 200 (local)
Client-to-client reflection is enabled
Cluster ID is 1.1.1.1
Route-target filter is enabled
Default IPv4-unicast is enabled
Check next-hops of vpn routes is disabled
Redistribution of iBGP routes is disabled
Graceful restart is globally disabled
Global graceful-restart restart time is 120 seconds
Global graceful-restart stale paths time is 360 seconds
Graceful-restart path selection defer time is 360 seconds
Graceful-restart is not ready to switch to the standby SRP
The last restart was not graceful
Local-RIB version 11. FIB version 11.
AS State
100 Established
Chapter 11: Monitoring VPLS
MED LocPrf Weight Origin
0 IGP
0 IGP
100
0 IGP
100
0 IGP
Messages
Messages
Up/down time
Sent
Received
00:30:35
65
Monitoring Layer 2 NLRI for VPLS Instances
Prefixes
Received
65
2
627

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose

Table of Contents