Table 77: Commands To Configure Basic Vpls Instances - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

JUNOSe 11.0.x BGP and MPLS Configuration Guide
Configuration Tasks for VPLS with BGP Signaling
To configure VPLS with BGP signaling on the PE router:
1.
2.
3.
4.
5.
6.
7.
8.
Related Topics
Configuring VPLS Instances with BGP Signaling
You must configure a VPLS instance for each VPLS domain in which the router
participates. From a configuration standpoint, a VPLS instance is simply a new or
existing bridge group that you configure with additional VPLS attributes.
Table 77 on page 584 lists the commands that you use to configure a basic VPLS
instance, as described in this section.

Table 77: Commands to Configure Basic VPLS Instances

584
Configuration Tasks for VPLS with BGP Signaling
Configure a single instance of VPLS, known as a VPLS instance, on the PE router
for each VPLS domain in which the router participates.
(Optional) Configure BGP multihoming for the customer site.
(Optional) Configure optional attributes for the VPLS instance.
Configure network interfaces to connect the PE router to each CE device.
(Optional) Configure nondefault subscriber policies for the VPLS network interface.
Configure a loopback interface and assign a router ID that uses the IP address
of the loopback interface.
Configure MPLS label-switched paths (LSPs) to connect local and remote PE
routers.
Set up BGP signaling on the autonomous system configured to signal reachability
for this VPLS instance.
Configuring VPLS Instances with BGP Signaling on page 584
Configuring Optional Attributes for VPLS Instances on page 587
Configuring VPLS Network Interfaces on page 588
Configuring Subscriber Policies for VPLS Network Interfaces on page 589
Configuring the Loopback Interface and Router ID for VPLS on page 592
Configuring MPLS LSPs for VPLS on page 593
Configuring BGP Signaling for VPLS on page 594
See VPLS Configuration Example with BGP Signaling on page 595 for a detailed
sample configuration.
bridge vpls rd
bridge vpls route-target
bridge vpls site-range
bridge vpls transport-virtual-routers