Table 107: Show L2Vpn Connections Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

LN = Local Site not Designated
RN = Remote Site not Designated
Site
----
2
3
Table 107 on page 681 lists the show l2vpn connections command output fields.
Meaning

Table 107: show l2vpn connections Output Fields

Related Topics
Monitoring VPWS Instances
To display configuration and status information for VPWS instances configured on
Purpose
the router. You can display information for all VPWS instances or information about
a particular VPWS instance. The detail keyword displays detailed information about
the specified VPWS instance or all VPWS instances.
To display information about all VPWS instances configured on the router:
Action
Remote
State PE In-label
----- ------- --------
UP 2.2.2.2 17
UP 2.2.2.2 18
Field Name Field Description
L2VPN Name of the VPWS instance
Encapsulation Type Encapsulation type configured for the VPWS instance
Use of control word Local preference for control word, preferred or not preferred
sequence numbers Local preference for sequence number, send or don't send
Route Distinguisher Route distinguisher configured for the VPWS instance
Site Range Maximum number of customer sites allowed in the VPWS instance
Sites Site name and site ID for each customer site in the VPWS instance
Multihomed priority Priority of the VPWS instance to serve as the backup PE router for
the CE device in the event of a network failure in the multihomed
configuration; indicates also that the site is multihomed
Route Targets Route targets configured for the VPWS instance
Interface Layer 2 interface that is a member of the VPWS instance
Local-Site-Id Local customer site ID configured on the layer 2 interface
Remote-Site-Id Remote customer site ID configured on the layer 2 interface
show l2vpn connections
Chapter 14: Monitoring VPWS
MPLS
Out-label NH Idx
--------- -------- -----------
801024 00000014 1d 08:45:34
801028 00000014 1d 08:45:34
Monitoring VPWS Instances
Up-down
Time
681