Monitoring Virtual Router Configuration; Monitoring Ip And Ipv6 Tunnel Routing Tables - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 34: show cac interface Output Fields (continued)
Related Topics

Monitoring Virtual Router Configuration

Display the configuration of all virtual routers or a specific virtual router.
Purpose
To display VR configuration:
Action
host1#show configuration virtual-router euro7
Related Topics

Monitoring IP and IPv6 Tunnel Routing Tables

Display the current state of the IPv4 or IPv6 tunnel routing table.
Purpose
To display information about all IP tunnel routes:
Action
host1:vr2# show ip tunnel-route all
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VRF, *- via indirect next-hop
Field Name Field Description
current total available bw Total bandwidth in Kbps that is available to be reserved
MPLS TE flooding threshold Absolute percentages of total reservable bandwidth that trigger the
up/down flooding of the new bandwidth value throughout the network;
flooding is triggered when bandwidth increases past any of the up
threshold values and when bandwidth decreases past any of the
down threshold values
MPLS TE administrative Weight assigned to the interface that supersedes a weight assigned
weight by the IGP
MPLS TE attribute flags 32-bit value that assigns the interface to a resource class and
enables a tunnel to discriminate among interfaces by matching
against tunnel affinity bits
Available BW at 8 priority Bandwidth in Kbps that is available at each priority level in the
levels range 0–7
show cac interface
show configuration
Chapter 4: Monitoring MPLS
Monitoring Virtual Router Configuration
323