Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 203

show ip bgp aggregate-address
show bgp ipv6 aggregate-address
host1# show bgp ipv6 aggregate-address
Prefix AS set
3ffe::/48 No
show ip bgp cidr-only
MED Multiexit discriminator for the route
LocPrf Local preference for the route
Weight Assigned path weight
Origin Origin of the route
Example
host1#show ip bgp neighbors 5.72.116.1 advertised-routes
Local BGP identifier 2.2.2.2, local AS 2222
0 routes (0 bytes used), 0 distinct destinations (0 bytes used)
0 routes selected for route table installation
0 path attribute entries (0 bytes used)
Status codes: > best, * invalid, s suppressed, d dampened, r rejected
Prefix
> 0.0.0.0/0
> 10.10.0.87/32
> 13.13.13.13/32
> 33.0.0.0/16
> 33.0.0.0/24
> 44.44.0.0/16
See show ip bgp advertised-routes.
See show bgp ipv6 advertised-routes.
Use to display information about aggregate addresses.
Field descriptions
Prefix Prefix of the aggregate address
AS set ASs in the AS-set path
Summary only Displays a summary of aggregate address information
Attribute map Displays the attribute maps for aggregate addresses
Advertise map Displays the advertise maps for aggregate addresses
Example
Summ only Attribute map
No None
See show ip bgp aggregate-address.
See show bgp ipv6 aggregate-address.
Peer Next-hop
5.72.116.1 5.72.1.1
5.72.116.1 5.72.1.1
5.72.116.1 5.72.1.1
0.0.0.0 5.72.1.1
0.0.0.0 5.72.1.1
5.72.116.1 5.72.1.1
Advertise map Suppress map
None None
Chapter 1: Configuring BGP Routing
MED LocPrf Weight Origin
0 IGP
0 inc.
0 IGP
1 32768 inc.
1 32768 inc.
0 inc.
167
Monitoring BGP