Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 530

JUNOSe 11.1.x BGP and MPLS Configuration Guide
show ip route vrf
494
Monitoring BGP/MPLS VPNs
flushed interval Current setting of the flush timer (in seconds)
Filter applied to outgoing route update Access list applied to outgoing
RIP route updates
Filter applied to incoming route update Access list applied to incoming
RIP route updates
Global route map Route map that specifies all RIP interfaces on the
router
Distance Value added to RIP routes added to the IP routing table. The
default is 120.
Interface Interface type on which RIP protocol is running
Redistributing Protocol to which RIP is redistributing routes
Routing for Networks Network for which RIP is currently injecting
routes
Example
host1:pe1#show ip protocols vrf pe13
Routing Protocol is " ospf 1" with Router ID 13.13.13.1
Distance is 110
Redistributing: bgp
Address Summarization:
None
Routing for Networks:
13.13.13.0/255.255.255.0 area 0.0.0.0
See show ip protocols.
Use to display the routing table of the specified VRF.
Field descriptions
Protocol/Route type codes Type of route
Prefix/Length Network prefix for route in VRF routing table
Type Protocol of route
Next Hop IP address of the next hop to reach route
Dist/Met Administrative distance and metric applied to route
Intf Outgoing interface to reach route
Example
host1#show ip route vrf vpn2
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,