Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 710

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Table 104: Commands for Monitoring BGP Settings for the VPWS Address Family
For more information about using the show ip bgp commands that are not described
in this section, see "Configuring BGP Routing" on page 3 and "Configuring BGP-MPLS
Applications" on page 379.
Display layer 2 NLRI for all VPWS instances in the L2VPN address family, for a
Purpose
particular VPWS instance in the L2VPN address family, or for a particular VPWS
instance in the VPWS address family.
The l2vpn vpws keywords display layer 2 NLRI for a particular VPWS instance in the
VPWS address family.
The l2vpn all keywords display layer 2 NLRI for all VPWS instances in the L2VPN
address family. The output for this version of the command also includes information
about any VPLS instances configured in the L2VPN address family.
To display layer 2 NLRI for the route that matches a specified prefix (site ID and
block offset) in the L2VPN address family or in the VPWS address family, use the
site-id and block-offset keywords.
To display information for a particular L2VPN instance in the L2VPN address family:
Action
host1:pe1# show ip bgp l2vpn vpws l2vpn1
Local BGP identifier 10.1.1.1, local AS 100
2 routes (152 bytes)
2 destinations (152 bytes) of which 2 have a route
2 routes selected for route tables installation
0 unicast/multicast routes selected for route table installation
0 unicast/multicast tunnel-usable routes selected for route table installation
0 tunnel-only routes selected for tunnel-route table installation
4 path attribute entries (608 bytes)
Local-RIB version 6. FIB version 6.
Status codes: > best, * invalid, s suppressed, d dampened, r rejected,
a auto-summarized m multihomed-backup
Prefix Peer
> 1:1 0.0.0.0
> 2:1 12.2.2.2
To display summary information for a particular VPWS instance in the VPWS address
family; only the BGP operational state is useful:
host1:pe1# show ip bgp l2vpn vpws l2vpn1 summary
Local router ID 10.1.1.1, local AS 100
674
Monitoring BGP-Related Settings for VPWS L2VPNs
(continued)
show ip bgp filter-list
show ip bgp flap-statistics
Next-hop MED LocPrf Weight Origin
self
12.2.2.2
Administrative state is Start
BGP Operational state is Up
Shutdown in overload state is disabled
Default local preference is 100
Default originate is disabled
show ip bgp regexp
show ip bgp summary
0 IGP
100 0 IGP