Table of Contents
Advertisement
Chapter 13
Configuring VPWS
Before You Configure VPWS
Related Topics
This chapter describes how to configure virtual private wire service (VPWS) L2VPNs
on the router, and contains the following sections:
Before You Configure VPWS on page 657
VPWS Configuration Tasks on page 658
Configuring a VPWS Instance on page 659
Configuring BGP Multihoming for VPWS on page 661
Configuring Customer-Facing Interfaces in the VPWS Instance on page 661
Configuring a Local Cross-Connect for VPWS on page 662
Configuring the Loopback Interface and Router ID for BGP for VPWS on page 663
Configuring BGP Signaling for VPWS on page 664
Configuring MPLS LSPs for VPWS on page 665
VPWS Configuration Example on page 666
The JUNOSe software implementation of VPWS uses features of BGP, MPLS, BGP/MPLS
VPNs, and layer 2 services over MPLS. We recommend you have a thorough
understanding of these protocols before you configure and use VPWS in your network.
For more information about configuring BGP, MPLS, BGP/MPLS VPNs, and layer 2
services over MPLS, see the following chapters in this guide:
Configuring BGP Routing on page 3
Configuring MPLS on page 267
Configuring BGP-MPLS Applications on page 379
Layer 2 Services over MPLS Overview on page 509
Configuring Layer 2 Services over MPLS on page 529
Monitoring Layer 2 Services over MPLS on page 563
For more information about configuring the layer 2 interfaces that support
L2VPNs, see Configuration Tasks for Ethernet in the JUNOSe Physical Layer
Configuration Guide
Before You Configure VPWS
657
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
