Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 202

JUNOSe 11.1.x BGP and MPLS Configuration Guide
show ip bgp advertised-routes
show bgp ipv6 advertised-routes
166
Monitoring BGP
0 tunnel-only routes selected for tunnel-route table installation
35097 path attribute entries (5334744 bytes)
Local-RIB version 20969483. FIB version 20969483.
Statistics baseline set WED JUL 12 2006 10:31:53 METDST
...
See show ip bgp.
See show bgp ipv6.
Use to display the routes in the specified neighbor's or peer group's Adj-RIBs-Out
table.
For peers, the attributes displayed are those associated with the route before the
application of any outbound policy.
For peer groups, the attributes displayed are those associated with the route after
the application of any outbound policy; that is, the actual advertised attributes.
Reports whether the indirect next hop of a route is unreachable; if not, displays
the IGP cost to the indirect next hop.
You must first enable storage of routes to the Adj-RIBs-Out tables with the
no rib-out disable command or the no neighbor rib-out disable command.
Otherwise, this command returns an error message.
If you filter the display with field options, the usual introductory information
about BGP attributes is displayed only if you issue the intro fields option. See
show ip bgp for descriptions of the fields displayed by this keyword.
Field descriptions
Local BGP identifier BGP router ID of the local router
routes Total number of routes stored in the BGP routing table. If several
peers have advertised a route to the same prefix, all routes are included in
this count.
distinct destinations Number of routes to unique prefixes stored in the BGP
routing table. If several peers have advertised a route to the same prefix,
only the best route is included in this count.
routes selected for route table installation Number of routes in the BGP
routing table that have been inserted into the IP routing table
path attribute entries Number of distinct path attributes stored in BGP's
internal path attributes table. If BGP receives two routes for different prefixes
but with identical path attributes, BGP will create only one entry in its internal
path attribute table and share it between the two routes to conserve memory.
Prefix Prefix for the routing table entry
Peer IP address of BGP peer
Next-hop IP address of the next hop