Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 728

JUNOSe 11.1.x BGP and MPLS Configuration Guide
ATM ports
changed to LOS state
and multiple VCs over a single
pseudowire..............................................526
configuring cell concatenation parameters
requirements...............................................528
connectivity between two of them
emulated using multiple VCs transport over
a pseudowire............................................524
not changed to LOS state
during a failure on the pseudowire..............526
ATM virtual circuits
....................................................................525
adding MPLS Martini circuit configuration
for multiple VCs transport over a
pseudowire..............................................525
and emulation of connectivity
between ATM ports.....................................524
based on RFC 4816
exception with subset of ATM cells
transport..................................................524
concatenation of multiple cells
requirements for configuring.......................528
configuring a subset of
using the mpls-relay atm vpi-range
command................................................525
configuring VPI/VCI ranges
....................................................................525
hardware limitations of ATM LMs
and transport of multiple VCs over a
pseudowire..............................................524
in Martini topologies
transportation over a single
pseudowire..............................................524
received on an ATM port
opening VCs on the SAR scheduler..............524
transmission of a subset of ATM cells over a
pseudowire
deployment scenario...................................560
transmission of multiple cells over a pseudowire
high availability and.....................................528
limit on total number of...............................528
performance impact ...................................528
unified ISSU and..........................................528
verifying cell concatenation.........................568
verifying VCI/VPI ranges..............................568
transmission of multiple VCs over a single
pseudowire
interoperation with cell relay on a
subinterface.............................................526
transport of multiple cells over a pseudowire
and ATM n-to-one VCC cell transport
(0x0009) pseudowire (PW) type ..............527
692
Index
transportation of cells from multiple circuits
over a single pseudowire.............................524
transportation of multiple ATM cells
concatetation...............................................526
atomic-aggregate, BGP.................................................11
attribute-map keyword (aggregate-address).................61
authentication
BGP.......................................................................33
MPLS
LDP MD5.....................................................285
RSVP-TE......................................................287
auto-summary command.............................................33
autoconfiguration, LDP..............................................283
autonomous system. See AS
B
backdoor link, OSPF..................................................479
backdoor route, BGP..................................................139
backup tunnels, MPLS RSVP-TE..................................288
bandwidth command.................................................275
baseline commands
baseline bridge...................................................614
baseline bridge interface.....................................614
baseline bridge interface vpls..............................614
baseline ip bgp ...................................................158
baseline mpls interface...............................316, 563
baseline mpls label.............................................317
baseline mpls next-hop.......................................318
BFD (Bidirectional Forwarding Detection)
BGP peer reachability detection..........................141
RSVP-TE, configuring for.....................................257
BGP (Border Gateway Protocol)......................................3
access lists............................................................83
administrative distance.......................................136
administrative shutdown......................................33
advertising networks in ASs..................................50
advertising routes conditionally............................62
advertising two best routes...................................52
aggregator path attribute......................................11
AS-path attribute...................................................11
atomic-aggregate path attribute............................11
authentication on TCP connection........................33
automatic fallover.................................................33
automatic summarization of routes......................33
backdoor routes..................................................139
BFD....................................................................141
and graceful restart......................................141
packet rates.................................................141
session events.............................................141
BGP/MPLS VPNs..................................................382
configuring sessions for...............................444
capabilities..........................................................126
capability negotiation..........................................126
changing BGP policies...........................................98
checking AS number from external peer...............62