Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 381

To display information about MPLS interface atm 2/0.60:
host1:pe2#show mpls interface atm 2/0.60
Interface atm2/0.60 Up
RSVP not configured
LDP enabled with profile default
IP interfaces on this MPLS interface:
60.60.60.1/16 Session to 4.4.4.4 is operational (active)
Session statistics:
12 label alloc, 12 label learned,
12 accum label alloc, 12 accum label learned,
last restart time = 00:04:44
Rcvd: 0 notf, 29 msg, 12 mapping, 0 request
0 abort, 0 release, 0 withdraw, 1 addr
0 addr withdraw, 29 msgId
0 bad mapping, 0 bad request, 0 bad abort, 0 bad release
0 bad withdraw, 0 bad addr, 0 bad addr withdraw
0 unknown msg type err
last info err code = 0x00000000, 0 loop detected
Sent: 0 notf, 29 msg, 12 mapping, 0 request
0 abort, 0 release, 0 withdraw, 1 addr
0 addr withdraw, 29 msgId
Adjacency statistics:
58 hello recv, 57 hello sent, 0 bad hello recv
adj setup time = 00:04:44
last hello recv time = 00:00:05, last hello sent time = 00:00:05
MPLS Statistics:
Rcvd: 0 failed lbl lookup, 0 octets, 0 hcOctets
0 pkts, 0 hcPkts, 0 errors, 0 discards
Sent: 0 octets, 0 hcOctets, 0 pkts
0 hcPkts, 0 errors, 0 discards
1 adjacency, 1 session, 3 accum adjacency, 3 accum session
14058 hello recv, 14063 hello sent, 0 hello rej
3 adj setup, 2 adj deleted
The following excerpt shows LDP and RSVP-TE information for MPLS interface atm
6/1.1:
host1:vr2#show mpls interface atm 6/1.1
...
MPLS major interface ATM6/1.1
ATM circuit type is 1483 LLC encapsulation
Administrative state is enabled
Operational state is up
Operational MTU is 9180
Received:
0 packets
0 bytes
0 errors
0 discards
0 failed label lookups
Sent:
0 packets
0 bytes
0 errors
0 discards
LDP information:
10.1.1.1/24
enabled with profile 'default'
0 hello recv, 2 hello sent, 0 hello rej
0 adj setup, 0 adj deleted,
Chapter 4: Monitoring MPLS
Monitoring MPLS Interfaces
345