Ldp Interface Tasks; Rsvp-Te Interface Tasks - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

LDP Interface Tasks

To configure LDP on the interface:
1.
2.

RSVP-TE Interface Tasks

To configure RSVP-TE on the interface:
1.
2.
3.
4.
5.
Start LDP on the interface.
Using the default values (an implicit default profile):
host1(config-if)#mpls ldp
Using a previously created profile:
host1(config-if)#mpls ldp profile ldp5
(Optional) Suppress transmission of link hello messages to all LSRs.
host1(config-if)#mpls ldp link-hello disable
Start RSVP-TE on the interface.
Using the default values (an implicit default profile):
host1(config-if)#mpls rsvp
Using a previously created profile:
host1(config-if)#mpls rsvp profile rsvp4
To disable RSVP-TE on the interface:
host1(config-if)#mpls rsvp disable
(Optional) Configure total bandwidth available on the interface.
host1(config-if)#bandwidth 262144
(Optional) Configure total bandwidth reservable for MPLS on the interface.
host1(config-if)#mpls bandwidth 4096
(Optional) Specify thresholds that trigger bandwidth flooding when crossed by
an increase or decrease in the total reservable bandwidth.
host1(config-if)#mpls traffic-eng flood thresholds up 15
host1(config-if)#mpls traffic-eng flood thresholds down 15
(Optional) Specify the resource attributes for the interface so that tunnels can
discriminate among interfaces.
host1(config-if)#mpls traffic-eng attribute-flags 0x000001f9
Chapter 3: Configuring MPLS
275
LDP Interface Tasks