Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 214

JUNOSe 11.1.x BGP and MPLS Configuration Guide
178
Monitoring BGP
negotiated BGP version BGP version being used to communicate with the
neighbor
Administrative status Desired state of the peer connection
Connection state Current state of the BGP connection
Connection has been established Time that TCP connection was established
Reason for last reset Reason for last reset of the BGP session
TCP error code TCP connection error type
Default originate Status of default originate (enabled or disabled)
EBGP multi-hop Status of EBGP multihop (enabled or disabled)
IBGP single-hop Status of IBGP single hop (enabled or disabled)
Next hop self Status of next-hop self (enabled or disabled)
Route reflector status Identifies the neighbor as a route-reflector client
Neighbor weight Weight of routes from the BGP neighbor
Incoming update distribute list Distribute list for incoming routes, if
configured
Outgoing update distribute list Distribute list for outgoing routes, if
configured
Incoming update filter list Update filter list for incoming routes, if configured
Outgoing update filter list Update filter list for outgoing route, if configured
Weight filter list Weight filter list for routes, if configured
Incoming route map Incoming route map, if configured
Outgoing route map Outgoing route map, if configured
Connect retry interval Time between a BGP peer's attempts to reestablish
a connection to the neighbor
Minimum route advertisement interval Minimum time between route
advertisements
Minimum AS origination interval Minimum time between advertisement
of changes within the speaker's AS
Configured keep-alive interval Frequency of keep-alive messages generated
Negotiated keepalive interval Negotiated frequency of keep-alive messages
generated
Configured hold time Configured maximum time allowed between received
messages