Monitoring Vpws Connections - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Related Topics

Monitoring VPWS Connections

Display configuration and status information for VPWS L2VPN connections configured
Purpose
on the router. The details keyword displays detailed information about the
connections.
To display detailed information about connections for all VPWS instances configured
Action
on the router:
host1:pe1# show l2vpn connections details
L2VPN: l2vpn1
Encapsulation Type Ethernet
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:11
Site Range 10
Sites:
Site Name westford Site Id 1
Multi-homed:
Site-Priority:
Route Target: RT:100:1 both
Interface Local-Site-Id
--------------- -------------
FastEthernet4/1 1
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
CM = Control Word Mismatch
LN = Local Site not Designated
RN = Remote Site not Designated
Local Remote
Site Site State
----- ------ -----
1 2 UP
L2VPN: l2vpn2
Encapsulation Type ATM AAL5 SDU VCC transport
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:12
Site Range 20
Sites:
Site Name boston Site Id 3
Multi-homed:
Site-Priority:
Route Target: RT:100:2 both
show ip bgp next-hops
Yes
45 Route Targets:
Remote-Site-Id
--------------
2
Remote
PE In-label Out-label
------- -------- ---------
2.2.2.2 25 74
Yes
100 Route Targets:
Admin Oper
state state
------- -----
enabled up
MPLS Up-down
NH Idx Time
-------- --------
0000001d 01:49:12
Monitoring VPWS Connections
Chapter 14: Monitoring VPWS
679