Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 538

JUNOSe 11.1.x BGP and MPLS Configuration Guide
502
Monitoring BGP/MPLS VPNs
active at a given time, this command does not give a complete picture of the
configuration.
Use the member-circuits keyword to display circuit information for the group.
Field descriptions
routed to/base LSP Identifies address of the router at the other end of the
tunnel and the base tunnel that is selected to forward the traffic
load-balancing group Group number
Martini group-id Martini group ID number for the interface
state State of the interface
vc-id VC ID number for the interface
mtu Maximum transmission unit for the interface
In label Label sent to upstream neighbor for route; statistics below this field
are the aggregate statistics for traffic from the core
Out label Label received from downstream neighbor for route; statistics
below this field are the aggregate statistics for traffic to the core
pkts Number of packets sent across tunnel
hcPkts Number of high-capacity (64-bit) packets sent across tunnel
octets Number of octets sent across tunnel
hcOctets Number of high-capacity (64-bit) octets sent across tunnel
errors Number of packets dropped for some reason before being sent
queue 0 Number of the queue for which statistics are being displayed and
whether the queue is under traffic class control
traffic class Name of traffic class
bound to Interface to which queue is bound
Queue length Size of queue in length and bytes
Forwarded Number of forwarded packets and bytes
Dropped committed Number of committed packets and bytes dropped
Dropped conformed Number of conformed packets and bytes dropped
Dropped exceeded Number of exceeded packets and bytes dropped
discardPkts Number of packets discarded due to lack of buffer space before
being sent
Member Interfaces Information about the member interfaces for the circuit