Chapter 11 Monitoring Vpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Chapter 11
Monitoring VPLS
This chapter describes the commands you can use to monitor and troubleshoot the
virtual private LAN service (VPLS) on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and
show commands is identical to output from other E Series routers, except that the
E120 and E320 router output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
This chapter contains the following sections:
Setting a Baseline for VPLS Statistics on page 614
Clearing Dynamic MAC Addresses from the VPLS Forwarding Table on page 615
Clearing BGP Attributes for VPLS on page 616
Monitoring Bridging-Related Settings for VPLS on page 617
Monitoring VPLS Configuration and Statistics for a Specific VPLS
Instance on page 618
Monitoring VPLS Configuration and Statistics for all VPLS Instances on page 620
Monitoring Configuration, Statistics, and Status for VPLS Network
Interfaces on page 622
Monitoring Configuration, Statistics, and Status for VPLS Core
Interfaces on page 625
Monitoring Configuration, Statistics, and Status for VPLS Ports on page 627
Monitoring MAC Address Entries for a Specific VPLS Instance on page 629
Monitoring Subscriber Policy Rules on page 630
Monitoring BGP-Related Settings for VPLS on page 631
Monitoring Layer 2 NLRI for VPLS Instances on page 632
Monitoring BGP Next Hops for VPLS on page 635
Monitoring LDP-Related Settings for VPLS on page 636
Monitoring MPLS-Related Settings for VPLS on page 637
Monitoring VPLS-Specific Settings on page 638
613