Configuring Mpls; Chapter 3 Configuring Mpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Chapter 3

Configuring MPLS

This chapter describes how to configure Multiprotocol Label Switching (MPLS) on the
router, and contains the following sections:
Basic MPLS Configuration Tasks on page 268
MPLS Global Configuration Tasks on page 269
LDP and RSVP-TE Interface Profile Configuration Tasks on page 273
MPLS Interface Configuration Tasks on page 274
MPLS Tunnel Configuration Tasks on page 276
MPLS Tunnel Profile Configuration Tasks on page 277
Configuring Explicit Routing for MPLS on page 279
Additional LDP Configuration Tasks on page 281
Configuring LDP FEC Deaggregation on page 281
Configuring LDP Graceful Restart on page 282
Configuring LDP Autoconfiguration on page 283
Configuring LDP-IGP Synchronization on page 284
Configuring LDP MD5 Authentication on page 285
Controlling LDP Label Distribution on page 286
Additional RSVP-TE Configuration Tasks on page 286
Configuring RSVP MD5 Authentication on page 287
Configuring RSVP-TE Fast Rerouting with RSVP-TE Bypass Tunnels on page 288
Configuring RSVP-TE Hello Messages to Determine Peer Reachability on page 291
Configuring RSVP-TE Graceful Restart on page 292
Configuring RSVP-TE Hellos Based on Node IDs on page 293
Configuring the BFD Protocol for RSVP-TE on page 294
Configuring IGPs and MPLS on page 295
Configuring MPLS and Differentiated Services on page 299
Configuring the Tunneling Model for Differentiated Services on page 299
Configuring EXP Bits for Differentiated Services on page 300
Example Differentiated Services Application and Configuration on page 300
267