Table 139: Show L2Vpn Connections Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x BGP and MPLS Configuration Guide
Meaning
680
Site Range 10
Sites:
Site Name westford Site Id 1
Multihomed priority 200
Route Targets:
Route Target: RT:100:2 both
Interface Local-Site-Id
---------- -------------
ATM2/0.100 1
ATM2/0.12 1
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
CM = Control Word Mismatch
LN = Local Site not Designated
RN = Remote Site not Designated
Remote
Site State PE
---- ----- -------
2 UP 2.2.2.2
3 UP 2.2.2.2
Table 139 on page 680 lists the show l2vpn connections command output fields.

Table 139: show l2vpn connections Output Fields

Field Name
L2VPN
Encapsulation Type
Use of control word
sequence numbers
Route Distinguisher
Site Range
Sites
Multihomed priority
Route Targets
Admin
Remote-Site-Id state
-------------- -------
2 enabled
3 enabled
In-label Out-label
-------- --------- --------
17 801024 00000014
18 801028 00000014
Field Description
Name of the VPWS instance
Encapsulation type configured for the VPWS instance
Local preference for control word, preferred or not preferred
Local preference for sequence number, send or don't send
Route distinguisher configured for the VPWS instance
Maximum number of customer sites allowed in the VPWS instance
Site name and site ID for each customer site in the VPWS instance
Priority of the VPWS instance to serve as the backup PE router for
the CE device in the event of a network failure in the multihomed
configuration; indicates also that the site is multihomed
Route targets configured for the VPWS instance
Oper
state
-----
up
up
MPLS Up-down
NH Idx Time
-----------
1d 08:45:34
1d 08:45:34
Copyright © 2010, Juniper Networks, Inc.