Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 167

clear ip bgp wait-end-of-rib
neighbor graceful-restart
neighbor graceful-restart restart-time
Specify an interval longer than the restart time.
This command takes effect immediately and automatically bounces the session.
Example
host1(config-router)#bgp graceful-restart stalepaths-time 480
Use the no version to restore the default value, 360 seconds.
See bgp graceful-restart stalepaths-time.
Use to clear a peer or peer group from the set of peers for which BGP is waiting
to receive an End-of-RIB marker after a peer restart.
Alternatively, performing a hard clear of a peer without this keyword has the
same effect.
This command takes effect immediately.
Example
host1#clear ip bgp 192.168.1.158 wait-end-of-rib
There is no no version.
See clear ip bgp wait-end-of-rib.
Use to control the advertisement of the BGP graceful restart capability for specified
peers or peer groups.
Advertisement of the graceful restart capability is disabled by default.
The no neighbor capability negotiation command prevents the advertisement
of all BGP capabilities, including graceful restart, to the specified peers, but does
not affect global advertisement of the graceful restart capability.
This command takes effect immediately and automatically bounces the session.
Example
host1(config-router)#no neighbor 10.21.3.5 graceful-restart
Use the no version to disable advertisement of the graceful restart capability for
specified peers or peer groups. Use the default version to remove the explicit
configuration from the peer or peer group and reestablish inheritance of the
capability configuration.
See neighbor graceful-restart.
Use to set the time BGP advertises to specified peers or peer groups within which
it expects to reestablish a session after restarting. Peers flush stale routes from
the speaker if the session is not restarted within this period.
Specify an interval shorter than the stalepaths time.
Chapter 1: Configuring BGP Routing
Selecting the Best Path
131