Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 540

JUNOSe 11.1.x BGP and MPLS Configuration Guide
show mpls tunnels
undebug ip mbgp
504
Monitoring BGP/MPLS VPNs
Use to display status and configuration for all tunnels or for a specific tunnel in
the current router context.
A result of Incomplete Configuration in the display indicates either no tunnel
endpoint or no label distribution protocol.
Field descriptions
State Status of tunnel, up or down
Out Label In the default case for a BGP/MPLS VPN, the Variable Interface,
which indicates that a packet exiting the interface is going through a variable
interface and that one of the labels listed further in the display will be
prepended to the packet
Mpls Statistics
pkts Number of packets sent across tunnel
hcpkts Number of high-capacity (64-bit) packets sent across tunnel
octets Number of octets sent across tunnel
hcoctets Number of high-capacity (64-bit) octets sent across tunnel
errors Number of packets that are dropped for some reason before
being sent
discardPkts Number of packets that are discarded due to lack of buffer
space before being sent
Labels List of labels associated with the variable interface; one will be
selected to be prepended to packets before being sent across tunnel
Example
host12#show mpls tunnels
LSP vpnIngress-21 to
State: Up
Out label is Variable Interface
102 pkts, 0 hcPkts, 13464 octets
0 hcOctets, 0 errors, 0 discardPkts
Labels:
16 17 18 19
See show mpls tunnels.
Use to disable the display of information about MP-BGP logs that was previously
enabled with the debug ip mbgp command.
Example
host1#undebug ip mbgp
3.3.3.3