Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 704

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Configuration on PE 2 (Remote PE Router)
Use the following commands on the remote PE router (PE 2) to configure the VPWS
topology shown in Figure 134 on page 666.
668
VPWS Configuration Example
host1(config)#interface gigabitEthernet 1/1
host1(config-subif)#l2vpn l2vpnB local-site-id 2 remote-site-id 4
host1(config-if)#exit
!
! Configure a loopback interface on PE 1 and assign it an IP address.
host1(config)#interface loopback 0
host1(config-if)#ip address 10.1.1.1 255.255.255.255
host1(config-if)#exit
!
! Assign the router ID for PE 1 using the IP address of the loopback interface.
host1(config)#ip router-id 10.3.3.3
!
! Configure BGP signaling.
host1(config)#router bgp 738
host1(config-router)#neighbor 10.1.1.1 remote-as 738
host1(config-router)#neighbor 10.1.1.1 update-source loopback 0
host1(config-router)#neighbor 10.1.1.1 next-hop-self
host1(config-router)#address-family l2vpn signaling
host1(config-router-af)#neighbor 10.1.1.1 activate
host1(config-router-af)#neighbor 10.1.1.1 next-hop-self
host1(config-router-af)#exit-address-family
host1(config-router)#address-family vpws l2vpnA
host1(config-router-af)#exit-address-family
host1(config-router)#address-family vpws l2vpnB
host1(config-router-af)#exit-address-family
!
! Enable MPLS on the default virtual router.
host1(config)#mpls
! Configure ATM core-facing interface 2/0.100 between PE 1 and the P router,
host1(config)#interface atm 2/0.100
host1(config-subif)#atm pvc 100 1 100 aal5snap 0 0 0
! and assign it an IP address.
host1(config-subif)#ip address 192.168.5.5 255.255.255.0
!
! Enable MPLS, LDP, and topology-driven LSPs on the core-facing interface.
host1(config-subif)#mpls
host1(config-subif)#mpls ldp
host1(config-subif)#exit
! Configure VPWS instance l2vpnA. The route target (100:1)
! matches the route target configured for l2vpnA on PE 1.
host2(config)#l2vpn l2vpnA encapsulation-type ethernet
host2(config)#l2vpn l2vpnA site-range 10
host2(config)#l2vpn l2vpnA site-name chicago site-id 3
host2(config)#l2vpn l2vpnA rd 100:11
host2(config)#l2vpn l2vpnA route-target both 100:1
host2(config)#l2vpn l2vpnA control-word
host2(config)#l2vpn l2vpnA sequencing
!
! Configure VPWS instance l2vpnB. The route target (100:2)