Mark Ip-Precedence; Police-Simple - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

14.4.8 mark ip-precedence

This command marks all packets for the associated traffic stream with the specified IP
Precedence value. The IP Precedence value is an integer from 0 to 7.
Format
Mode
Policy Type
Incompatibilities

14.4.9 police-simple

This command is used to establish the traffic policing style for the specified class. The
simple form of the police command uses a single data rate and burst size, resulting in two
outcomes: conform and violate. The conforming data rate is specified in kilobits-per-
second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is
specified in kilobytes (KB) and is an integer from 1 to 128.
For each outcome, the only possible actions are drop, set-cos-transmit, set-dscp-transmit,
set-prec-transmit, or transmit. In this simple form of the police command, the conform
action defaults to transmit and the violate action defaults to drop.
For set-dscp-transmit, a
from 0 to 63, or symbolically through one of the following keywords:
af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
For set-prec-transmit, an IP Precedence value is required. It is an integer from 0-7.
For set-cos-transmit an 802.1p priority value is required. It is an integer from 0-7.
Format
Mode
Incompatibilities
14-22
mark ip-precedence <0-7>
Policy-Class-Map Config
In
Drop, Mark CoS, Mark IP DSCP, Police
value is required and is specified as either an integer
<dscpval>
police-simple {<1-4294967295> <1-128> conform-
action {drop | set-prec-transmit <0-7> | set-dscp-
transmit <0-63> | set-cos-transmit <0-7> | trans-
mit} [violate-action {drop | set-prec-transmit <0-
7> | set-dscp-transmit <0-63> | set-cos-transmit
<0-7> | transmit}]}
Policy-Class-Map Config
Drop, Mark (all forms)
v1.0, February 2007
af11, af12, af13, af21,
.
Quality of Service (QoS) Commands