NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual page 180

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Control Mode
Operating Control
Mode
Reauthentication
Enabled
Key Transmission
Enabled
If you use the optional
configuration for the specified port are displayed.
Port
Protocol Version
PAE Capabilities
Authenticator PAE
State
Backend
Authentication
State
Quiet Period
Transmit Period
11-10
The configured control mode for this port. Possible values are
force-unauthorized | force-authorized | auto.
The control mode under which this port is operating. Possible
values are authorized | unauthorized.
Indicates whether re-authentication is enabled on this port.
Indicates if the key is transmitted to the supplicant for the
specified port.
[detail <slot/port>]
The interface whose configuration is displayed.
The protocol version associated with this port. The only pos-
sible value is 1, corresponding to the first version of the dot1x
specification.
The port access entity (PAE) functionality of this port. Possi-
ble values are Authenticator or Supplicant.
Current state of the authenticator PAE state machine. Possible
values are Initialize, Disconnected, Connecting, Authenticat-
ing, Authenticated, Aborting, Held, ForceAuthorized, and
ForceUnauthorized.
Current state of the backend authentication state machine.
Possible values are Request, Response, Success, Fail, Time-
out, Idle, and Initialize.
The timer used by the authenticator state machine on this port
to define periods of time in which it will not attempt to
acquire a supplicant. The value is expressed in seconds and
will be in the range 0 and 65535.
The timer used by the authenticator state machine on the
specified port to determine when to send an EAPOL EAP
Request/Identity frame to the supplicant. The value, in sec-
onds, has a range of 1 - 65535.
Port-Based Access and Authentication Commands
v1.0, February 2007
parameter, the detailed dot1x