NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual page 243

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
A rule may either deny or permit traffic according to the specified classification fields. At
a minimum, the source and destination MAC value must be specified, each of which may
be substituted using the keyword any to indicate a match on any value in that field. The
remaining command parameters are all optional, but the most frequently used parameters
appear in the same relative order as shown in the command format.
You can specify the Ethertype value as either a keyword or a four-digit hexadecimal value
from 0x0600-0xFFFF. The currently supported
arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of
these translates into its equivalent Ethertype value(s), as shown in
Table 14-1. Ethertype Keyword and 4-digit Hexadecimal Value
Ethertype Keyword
appletalk
arp
ibmsna
ipv4
ipv6
ipx
mplsmcast
mplsucast
netbios
novell
pppoe
rarp
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first
(or outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for
handling traffic that matches this rule. The allowed
is the number of user configurable queues available for the hardware platform. The assign-
queue parameters are only valid for a 'permit' rule.
Note: The special command form
Quality of Service (QoS) Commands
Corresponding Value
0x809B
0x0806
0x80D5
0x0800
0x86DD
0x8037
0x8848
0x8847
0x8191
0x8137, 0x8138
0x8863, 0x8864
0x8035
Ethernet layer 2 packets, and is the equivalent of the IP access list "match
every" rule.
v1.0, February 2007
<ethertypekey>
<queue-id>
{deny|permit} any any
values are: appletalk,
Table 14-1.
value is 0-(n-1), where n
is used to match all
14-33