Class-Map - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Note: Once you create a class match criterion for a class, you cannot change or
The CLI command root is

14.3.1 class-map

This command defines a DiffServ class of type match-all. When used without any match
condition, this command enters the class-map mode. The
sensitive alphanumeric string from 1 to 31 characters uniquely identifying an existing
DiffServ class.
Note: The class-map-name 'default' is reserved and must not be used.
The class type of
for a packet to be considered a member of the class.
Note: The CLI mode is changed to Class-Map Config when this command is
Format
Mode
14.3.1.1 no class-map
This command eliminates an existing DiffServ class. The
of an existing DiffServ class ( The class name 'default' is reserved and is not allowed here).
This command may be issued at any time; if the class is currently referenced by one or
more policies or by any other class, the delete action fails.
Format
Mode
14-10
delete the criterion. To change or delete a class match criterion, you must
delete and re-create the entire class.
class-map
indicates all of the individual match conditions must be true
match-all
successfully executed.
class-map match-all <class-map-name>
Global Config
no class-map <class-map-name>
Global Config
v1.0, February 2007
.
<class-map-name>
<class-map-name>
Quality of Service (QoS) Commands
is a case
is the name