NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual page 42

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
The following is an example of an ezconfig session.
NETGEAR EZ Configuration Utility
--------------------------------
Hello and Welcome!
This utility will walk you thru assigning the IP address for the switch
management CPU. It will allow you to save the changes at the end. After
the session, simply use the newly assigned IP address to access the Web
GUI using any public domain Web browser.
Admin password not defined. Do you want to change the password?
(Y/N/Q) y
Enter new password:********
Confirm new password:********
Password Changed!
The 'enable' password required for switch configuration via the command
line interface is currently not configured. Do you wish to change it (Y/
N/Q)? y
Enter new password:********
Confirm new password:********
Password Changed!
Assigning an IP address to your switch management
Current IP Address Configuration
--------------------------------
IP address: 0.0.0.0
Subnet mask: 0.0.0.0
Gateway address: 0.0.0.0
Would you like to assign an IP address now (Y/N/Q)?
IP Address: 10.10.10.1
Subnet mask: 255.255.255.0
Gateway address: 10.10.10.10
Do you want to assign switch name and location information (Y/N/Q)?
System Name: testunit1
System Location: testlab
System Contact: Bud Lightyear
3-6
v1.0, February 2007
y
Administrative Access Commands
y