Spanning-Tree Mst Priority - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
5.1.13.1 no spanning-tree mst instance
This command removes a multiple spanning tree instance from the switch and reallocates
all VLANs allocated to the deleted instance to the common and internal spanning tree. The
parameter
<mstid>
tree instance to be removed.
Format
Mode

5.1.14 spanning-tree mst priority

This command sets the bridge priority for a specific multiple spanning tree instance. The
parameter
<mstid>
tree instance. The priority value is a number within a range of 0 to 61440 in increments of
4096.
If you specify 0 (defined as the default CIST ID) as the
Bridge Priority parameter to a new value for the common and internal spanning tree. The
bridge priority value is a number within a range of 0 to 61440. The twelve least significant
bits are masked according to the 802.1s specification. This causes the priority to be
rounded down to the next lower valid priority.
Default
Format
Mode
5.1.14.1 no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to the
default value, i.e. 32768. The parameter
desired existing multiple spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the
Bridge Priority parameter for the common and internal spanning tree to the default value,
i.e. 32768.
Format
Mode
5-8
is a number that corresponds to the desired existing multiple spanning
no spanning-tree mst instance <mstid>
Global Config
is a number that corresponds to the desired existing multiple spanning
32768
spanning-tree mst priority <mstid> <0-61440>
Global Config
<mstid>
spanning-tree mst priority <mstid>
Global Config
v1.0, February 2007
, this command sets the
<mstid>
is a number that corresponds to the
, this command sets the
<mstid>
Spanning Tree Protocol Commands