Auto-Negotiate; Auto-Negotiate All - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

4.1.6 auto-negotiate

This command enables automatic negotiation on a port.
Default
Format
Mode
4.1.6.1 no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is disabled.
Format
Mode

4.1.7 auto-negotiate all

This command enables automatic negotiation on all ports. The default value is enable.
Format
Mode
4.1.7.1 no auto-negotiate all
This command disables automatic negotiation on all ports.
Format
Mode
Port and System Setup Commands
enabled
auto-negotiate
Interface Config
no auto-negotiate
Interface Config
auto-negotiate all
Global Config
no auto-negotiate all
Global Config
v1.0, February 2007
4-3