Match Cos - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
• Any attempts to delete the
any
<class-map-name>
• The combined match criteria of
allowed combination based on the class type.
• Any subsequent changes to the
this validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain
(including both predecessor and successor classes) must not exceed a platform-
specific maximum. In some cases, each removal of a refclass rule reduces the
maximum number of available rules in the class definition by one.
14.3.5.1 no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class. The
whose match conditions are being referenced by the specified class definition.
Format
Mode

14.3.6 match cos

This command adds to the specified class definition a match condition for the Class of
Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a
double VLAN tagged packet). The value may be from 0 to 7.
Default
Format
Mode
14-12
class while the class is still referenced by
<refclassname>
fails.
<class-map-name>
<refclassname>
is the name of an existing DiffServ class
<refclassname>
no match class-map <refclassname>
Class-Map Config
none
<0-7>
match cos
Class-Map Config
v1.0, February 2007
and
<refclassname>
class match criteria must maintain
Quality of Service (QoS) Commands
must be an