Snmp-Server Community Ro; Snmp-Server Community Rw; Snmp-Server Traps Violation - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
10.1.5.1 no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no SNMP
requests using this community are accepted. In this case the SNMP manager associated
with this community cannot manage the switch until the Status is changed back to Enable.
Format
Mode

10.1.6 snmp-server community ro

This command restricts access to switch information. The access mode is read-only (also
called public).
Format
Mode

10.1.7 snmp-server community rw

This command restricts access to switch information. The access mode is read/write (also
called private).
Format
Mode

10.1.8 snmp-server traps violation

This command enables the sending of new violation traps designating when a packet with
a disallowed MAC address is received on a locked port.
Note: For other port security commands, see
Default
Format
Mode
10-4
no snmp-server community mode <name>
Global Config
snmp-server community ro <name>
Global Config
snmp-server community rw <name>
Global Config
Commands" on page 9-1.
disabled
snmp-server traps violation
Interface Config
v1.0, February 2007
Section 9.1 "Port Security
SNMP Commands