NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual page 103

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Designated Port
Cost
Designated
Bridge
Designated Port
Identifier
If you specify 0 (defined as the default CIST ID) as the
the settings and parameters for a specific switch port within the common and internal
spanning tree. The
displayed.
Port Identifier
Port Priority
Port Forwarding
State
Port Role
Port Path Cost
Designated Root
Designated Port
Cost
Designated
Bridge
Designated Port
Identifier
Topology Change
Acknowledgement Value of flag in next Configuration Bridge Protocol Data
Hello Time
Edge Port
Edge Port Status
Spanning Tree Protocol Commands
Path Cost offered to the LAN by the Designated Port
B
ridge Identifier of the bridge with the Designated Port.
Port on the Designated Bridge that offers the lowest cost to
the LAN.
is the desired switch port. In this case, the following are
<slot/port>
The port identifier for this port within the CST.
The priority of the port within the CST.
The forwarding state of the port within the CST.
The role of the specified interface within the CST.
The configured path cost for the specified interface.
Identifier of the designated root for this port within the CST.
Path Cost offered to the LAN by the Designated Port.
The bridge containing the designated port
Port on the Designated Bridge that offers the lowest cost to
the LAN
Unit (BPDU) transmission indicating if a topology change is
in progress for this port.
The hello time in use for this port.
The configured value indicating if this port is an edge port.
The derived value of the edge port status. True if operating as
an edge port; false otherwise.
v1.0, February 2007
, this command displays
<mstid>
5-15