Vlan Port Pvid All; Vlan Port Tagging All - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
6.1.10.1 no vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces to Admit All. For Admit
All mode, untagged frames or priority frames received on this interface are accepted and
assigned the value of the interface VLAN ID for this port. With either option, VLAN
tagged frames are forwarded in accordance with the IEEE 802.1Q VLAN Specification.
Format
Mode

6.1.11 vlan port pvid all

This command changes the VLAN ID for all interface.
Default
Format
Mode
6.1.11.1 no vlan port pvid all
This command sets the VLAN ID for all interfaces to 1.
Format
Mode

6.1.12 vlan port tagging all

This command configures the tagging behavior for all interfaces in a VLAN to enabled. If
tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Format
Mode
6.1.12.1 no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
Mode
6-6
no vlan port acceptframe all
Global Config
1
vlan port pvid all <1-4094>
Global Config
no vlan port pvid all
Global Config
vlan port tagging all <1-4094>
Global Config
no vlan port tagging all
Global Config
v1.0, February 2007
VLAN Commands