NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual page 31

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Table 2-5. CLI Command Modes (continued)
Command Mode
Interface Config
Line Config
Policy Map Config
Policy Class Config
Class Map Config
Router OSPF
Config
Router RIP Config
MAC Access-list
Config
DHCP Pool Config
Stack Global
Config Mode
Overview
Prompt
Switch (Interface <unit/slot/
port>)#
Switch (line)#
Switch (Config policy-map)#
Switch (Config policy-class-map)#
Switch (Config class-map)#
Switch (Config router)#
Switch (Config router)#
Switch (Config mac-access-list)#
Switch (Config dhcp-pool)#
Switch (Config stack)#
v1.0, February 2007
Mode Description
Allows you to enable or modify
the operation of an interface and
provides access to the router
interface configuration
commands.
Use this mode to set up a
physical port for a specific logical
connection operation.
Allows you to configure various
telnet settings and the console
interface.
Allows you to access the QoS
Policy-Map configuration mode
to configure the QoS Policy-Map.
Consists of class creation,
deletion, and matching
commands. The class match
commands specify Layer 2,
Layer 3, and general match
criteria.
Allows you to access the QoS
Class-Map configuration mode to
configure QoS class maps.
Allows you to access the router
OSPF configuration commands.
Allows you to access the router
RIP configuration commands.
Allows you to create a MAC
Access-List and to enter the
mode containing Mac Access-
List configuration commands.
Allows you to access the DHCP
Pool configuration.
Allows you to access the Stack
Global Config Mode.
2-7