Installing Nm-Cids Offline - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Chapter 8 Installing NM-CIDS

Installing NM-CIDS Offline

You can install NM-CIDS in the chassis either before or after mounting the router, whichever is more
convenient.
Only trained and qualified personnel should be allowed to install or replace this equipment. To see
Warning
translations of the warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
ESD can damage equipment and impair electrical circuitry. Always follow ESD prevention procedures
Caution
when removing and replacing cards. For more information see
To install NM-CIDS, follow these steps:
Step 1 Turn OFF electrical power to the router.
To channel ESD voltages to ground, do not unplug the power cable.
Step 2 Remove all network interface cables, including telephone cables, from the back panel. The following
warning applies to routers that use a DC power supply:
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC
circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit
breaker in the OFF position.
Step 3 Using either a #1 Phillips screwdriver or a small flat-blade screwdriver, remove the blank filler panel
from the chassis slot where you plan to install NM-CIDS.
Save the blank panel for future use.
Step 4 Align NM-CIDS with the guides in the chassis and slide it gently into the slot.
ETHE RNET 0
Step 5 Push NM-CIDS into place until you feel its edge connector mate securely with the connector on the
motherboard.
Step 6 Fasten the captive mounting screws of NM-CIDS into the holes in the chassis, using a Phillips or
flat-blade screwdriver.
78-16124-01
WO
SERIA L
ASY NC
15
11
ASYN C 24-31
14
10
7
13 3
9 ASYN C 16-23
6
12 2
8
5
1
4
0
15
11
ASYN C 8-15
14
10
7
13 3
9
6
12 2
8
5
1
4
0
Network module
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Site and Safety Guidelines, page
ASYN C 0-7
EN
Router
Installation and Removal Instructions
1-17.
8-6