Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 96

Installing the Accessories
Figure 4-11
Secure the cables to the cable-management arm:
Step 3
After connecting the cables to the appliance, unscrew the thumbscrews that secure the front of the
a.
appliance to the front vertical rail.
Slide the appliance forward to the fully extended position.
b.
Route the cables along the cable-management arm, making any adjustments to the cable slack at the
c.
hinge positions, and secure the cables to the cable-management arm with the releaseable tie-wraps
and the wire covers over the cable-management arm.
Note
Step 4 Slide the appliance in and out of the rack to verify that the cables are routed correctly and do not bind,
stretch, or pinch with the movement of the cable-management arm.
Step 5 Make any necessary adjustments to ensure that the cable slack is neither too tight nor too loose, yet keeps
the cables in place as the appliance is moved in and out of the rack.
Step 6 Replace the rack doors.
Note
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
4-26
Routing Cables
As you pull the appliance out to its farthest extension, the slide assemblies lock in the
extended position. To push the appliance back into the rack, press the slide release latch on
the side of the slide, and then slide the appliance completely into the rack.
Refer to the procedures for replacing the rack doors in the documentation provided with the rack
cabinet.
Chapter 4 Installing IDS-4235 and IDS-4250
78-16124-01