Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 140

Installation and Removal Instructions
Installation and Removal Instructions
You must install NM-CIDS offline in Cisco 2650XM, 2651XM, and 2961 series routers.
To avoid damaging NM-CIDS, you must turn OFF electrical power and disconnect network cables before
Caution
you insert NM-CIDS into a chassis slot or remove NM-CIDS from a chassis slot.
Cisco 3660 and Cisco 3700 series routers lets you replace network modules without switching off the
router or affecting the operation of other interfaces. OIR provides uninterrupted operation to network
users, maintains routing information, and ensures session preservation.
Note Cisco 2600, 3600, and 3700 series routers support only one NM-CIDS per chassis.
Unlike other network modules, NM-CIDS uses a hard-disk drive. Online removal of hard-disk drives
Caution
without proper shutdown can result in file system corruption and might render the hard-disk drive
unusable. The operating system on NM-CIDS must be shut down in an orderly fashion before it is
removed.
This section contains the following topics:
•
•
•
•
Required Tools
You need the following tools and equipment to install NM-CIDS in a Cisco modular router chassis slot:
•
•
•
Installing NM-CIDS
This section describes how to install NM-CIDS off line and using OIR support, and contains the
following topics:
•
•
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
8-5
Required Tools, page 8-5
Installing NM-CIDS, page 8-5
Removing NM-CIDS, page 8-9
Blank Network Module Panels, page 8-11
#1 Phillips screwdriver or small flat-blade screwdriver
ESD-preventive wrist strap
Tape for DC circuit breaker handle
Installing NM-CIDS Offline, page 8-6
Installing NM-CIDS Using OIR Support, page 8-8
Chapter 8 Installing NM-CIDS
78-16124-01