Installing The Cisco Ncs 4201; Prerequisites; Installing The Chassis In A Rack - Cisco NCS 4201 Hardware Installation Manual

Installing the Cisco NCS 4201

This chapter describes how to install the Cisco NCS 4201 and includes the following sections:
•
•
•
•
•
•
•
•

Prerequisites

Before installing the Cisco NCS 4201, it is important to prepare for the installation by:
• Preparing the site (site planning) and reviewing the installation plans or method of procedures (MOP).
• Unpacking and inspecting the Cisco NCS 4201. See
• Gathering the tools and test equipment required to properly install the Cisco NCS 4201. See
For more instructions on how to prepare for the installation of the Cisco NCS 4201, see
chapter.

Installing the Chassis in a Rack

The procedures in this section apply to both horizontal and vertical mounting of the chassis in a rack:
Prerequisites, on page 33
Installing the Chassis in a Rack, on page 33
Installing and Removing the Front Door, on page 38
Installing and Removing the Fan Tray, on page 40
Installing the Power Supply, on page 42
Installing and Removing SFP Modules, on page 54
Installing the Chassis Ground Connection, on page 59
Connecting a Chassis to the Network, on page 62
See Site Planning section.
Equipment section.
3
C H A P T E R
Receiving the Chassis section.
Cisco NCS 4201 Hardware Installation Guide
Tools and
Preparing for Installation
33