Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 142

Installation and Removal Instructions
If the router was previously running, reinstall the network interface cables and turn ON power to the
Step 7
router.
Category 5
or UTP cable
The following warning applies to routers that use a DC power supply:
Warning After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position.
Step 8 Connect the command and control port to a hub or switch.
Step 9 Check that NM-CIDS indicators light up, and that the Active/Ready indicators on the front panel also
light up.
Step 10 Initialize NM-CIDS.
For the procedure, see
Step 11 Upgrade NM-CIDS to the most recent Cisco software.
For the procedure, see
You are now ready to configure intrusion detection on NM-CIDS.
For More Information
For the procedure for using HTTPS to log in to IDM, refer to
•
For the procedures for configuring intrusion prevention on your sensor, refer to the following
•
documents:
–
–
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
8-7
NM-CE-B P
DISK
LINK
ACT
PWR EN
FastEtherne t 0
Fast Ethernet
RJ-45
Initializing the Sensor, page
Obtaining Cisco IPS Software, page
Installing and Using Cisco Intrusion Prevention System Device Manager 5.0
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
5.0
CF
Fast Ethernet hub
9-2.
10-1.
Logging In to
Chapter 8 Installing NM-CIDS
IDM.
78-16124-01