Installing IPS-4240 and IPS-4255
Note
Note
Connect the RJ-45 connector to the console port and connect the other end to the DB-9 or DB-25
Step 5
connector on your computer.
Step 6
Attach the network cables.
•
GigabitEthernet0/0, GigabitEthernet0/1, GigabitEthernet0/2, and GigabitEthernet0/3 (from right to
left) are sensing ports.
•
Management0/0 is the command and control port.
Step 7
Power on the appliance.
Step 8
Initialize the appliance.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
5-8
Use the console port to connect to a computer to enter configuration commands. Locate the serial
cable from the accessory kit. The serial cable assembly consists of a 180/rollover cable with
RJ-45 connectors (DB-9 connector adapter PN 74-0495-01 and DB-25 connector adapter PN
29-0810-01).
You can use a 180/rollover or straight-through patch cable to connect the appliance to a port on
a terminal server with RJ-45 or hydra cable assembly connections. Connect the appropriate cable
from the console port on the appliance to a port on the terminal server. See
Appliance to a Terminal Server, page 1-9
FLASH
Console
port (RJ-45)
RJ-45 to
DB-9 or DB-25
serial cable
(null-modem)
Indicators
LNK SPD
LNK SPD
LNK SPD
2
3
for the instructions for setting up a terminal server.
Computer serial port
DB-9 or DB-25
LNK SPD
1
0
Chapter 5
Installing IPS-4240 and IPS-4255
Connecting an
78-16124-01