Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 69

Chapter 3 Installing IDS-4215
Remove the lower slot cover from the back cover plate.
Step 8
Attach the back cover plate making sure that the connecting flange on the 4FE card goes through the slot
Step 9
on the back cover plate.
Step 10 Tighten the single captive screw to hold the connecting flange of the 4FE card to the back cover plate,
and tighten the captive screws to attach the back cover plate to the appliance.
Step 11 Replace the chassis cover.
For the procedure, see
You will need to assign the new interfaces (FastEthernet1/0, FastEthernet1/1, FastEthernet1/2, and
FastEthernet1/3). For the CLI procedure, refer to
to Configuring
78-16124-01
Replacing the Chassis Cover, page
Interfaces.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Removing and Installing the 4FE Card
3-13.
Configuring Interfaces. For the IDM procedure, refer
3-23