Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 93

Chapter 4 Installing IDS-4235 and IDS-4250
Figure 4-8
Install the status-indicator cable plug into its connector (see
Step 5
Open the wire covers on the cable-management arm by lifting the center of the wire over the top of the
Step 6
embossed round button on the front of the forward part of the arm, and lifting the wire over the top of a
similar round button on the back part of the arm.
The wire cover swings open to enable cables to be routed within the arm.
Route the status-indicator end of the cable assembly through the cable-management arm, and install the
Step 7
indicator in its slot at the back end of the cable-management arm (see
78-16124-01
Cable-Management Arm
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Installing the Accessories
Figure 4-9 on page 4-24).
Figure 4-9 on page 4-24).
4-23