Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 42

Installing IDS-4210
Note
Attach the network cables.
Step 4
AC power
IDS-4210 has the following interfaces:
• FastEthernet0/0 is the sensing port.
• FastEthernet0/1 is the command and control port.
Step 5 Upgrade the memory on IDS-4210.
For the procedure, see
Caution You must upgrade the memory on IDS-4210 to a minimum of 512 MB before you can install the most
recent Cisco IPS software.
Power on IDS-4210.
Step 6
Initialize IDS-4210.
Step 7
For the procedure, see
Step 8 Upgrade IDS-4210 to the latest Cisco IPS software.
For the procedure, see
You are now ready to configure intrusion detection on the appliance.
For More Information
For the procedure for using HTTPS to log in to IDM, refer to
•
For the procedures for configuring intrusion prevention on your sensor, refer to the following
•
documents:
–
–
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
2-6
You can use a 180 rollover or straight-through patch cable to connect IDS-4210 to a port on a
terminal server with RJ-45 or hydra cable assembly connections. Use a M.A.S.H adapter (part
number 29-4077-02) to connect the appropriate cable to a port on the terminal server. For the
instructions for setting up a terminal server, see
page 1-9.
interface FastEthernet0/1
Mouse
(unused)
Keyboard
USB
(unused)
Upgrading the Memory, page
Initializing the Sensor, page
Obtaining Cisco IPS Software, page
Installing and Using Cisco Intrusion Prevention System Device Manager 5.0
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
5.0
Connecting an Appliance to a Terminal Server,
COM1
Sensing interface
FastEthernet0/0
2-3.
9-2.
10-1.
Chapter 2 Installing IDS-4210
Video
Logging In to IDM.
78-16124-01