Front And Back Panel Features - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Front and Back Panel Features

Front and Back Panel Features
This section describes the IDS-4215 front and back panel features and indicators.
Figure 3-1
Figure 3-1
POWER
Table 3-1
Table 3-1
Indicator
POWER
ACT
NETWORK
Figure 3-2
Figure 3-2
FastEthernet1/3
Warning Port numbering for onboard interfaces was reversed from IDS 4.x to IPS 5.0 and later. The port naming
convention changed within the IPS application only; the physical chassis label remains unchanged.
To correlate chassis port labels to software port names, refer to
The built-in Ethernet ports have three indicators per port and the 4FE card has two indicators per port.
Figure 3-3 on page 3-3
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
3-2
shows the front view of IDS-4215.
IDS-4215 Front Panel Features
ACT NETWORK
describes the front panel indicators on IDS-4215.
Front Panel Indicators
Description
Lights up when power supply is running.
Lights up when IDS-4215 has completed power-up self-test and has started the
operating system and application software loading process.
Blinks when network traffic is passing over either of the two built-in Ethernet ports;
does not indicate traffic on any of the four ports of the 4FE card.
shows the back view of IDS-4215.
IDS-4215 Back Panel Features
Empty PCI
slot
FastEthernet1/0
FastEthernet1/2
FastEthernet1/1
FastEthernet0/1 (sensing)
FastEthernet0/0 (command and control)
shows the back panel indicators.
CISCO IDS-4215
Intrusion Detection Sensor
USB
(unused)
10/100 ETHERNET 0 10/100 ETHERNET 1 USB CONSOLE
Off/on
Console
Chapter 3 Installing IDS-4215
Power
connector
Figure 3-2.
78-16124-01