Verifying The Status Of Aip-Ssm; Installation And Removal Instructions; Installing Aip-Ssm - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Intrusion prevention system appliances and modules 5.0
Hide thumbs Also See for IPS-4240-K9 - Intrusion Protection Sys 4240:
Table of Contents

Advertisement

Installation and Removal Instructions

Install the most recent Cisco IPS software.
Step 9
See
Configure AIP-SSM to receive IPS traffic.
Step 10
For the procedure, refer to
For More Information

Verifying the Status of AIP-SSM

You can use the show module 1 command to verify that AIP-SSM is up and running.
To verify the status of AIP-SSM, follow these steps:
Log in to ASA.
Step 1
Verify the status of AIP-SSM:
Step 2
asa# show module 1
Mod Card Type
--- -------------------------------------------- ------------------ -----------
1 ASA 5500 Series Security Services Module-20
Mod MAC Address Range
--- --------------------------------- ------------ ------------ ---------------
1 000b.fcf8.0144 to 000b.fcf8.0144
Mod Status
--- ------------------
1 Up
asa#
If the status reads
The following values are valid for the Status field:
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
6-4
Obtaining Cisco IPS Software, page 10-1
Sending Traffic to
For the procedure for using HTTPS to log in to IDM and ASDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following
documents:
Installing and Using Cisco Intrusion Prevention System Device Manager 5.0
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
5.0
, AIP-SSM has been properly installed.
Up
Initializing—AIP-SSM is being detected and the control communication is being initialized by the
system.
Up—AIP-SSM has completed initialization by the system.
Unresponsive—The system encountered an error communicating with AIP-SSM.
Reloading—AIP-SSM is reloading.
Shutting Down—AIP-SSM is shutting down.
for the procedure.
AIP-SSM.
Model
ASA-SSM-20
Hw Version
Fw Version
0.2
1.0(9)0
Chapter 6

Installing AIP-SSM

Logging In to
IDM.
Serial No.
P2B000005D0
Sw Version
5.0(0.27)S129.0
78-16124-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents