Catalyst Software; Cisco Ios Software; Powering Idsm-2 Up And Down - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Chapter 7 Installing IDSM-2

Powering IDSM-2 Up and Down

You can remove and restore power to IDSM-2 through the switch CLI. This section describes how to
power IDSM-2 up and down through the switch CLI, and contains the following sections:
•
•

Catalyst Software

Once you power off IDSM-2, you must power it up through the switch CLI.
The IDSM-2 CLI reset powerdown command performs a shut down, but does not remove power from
Note
IDSM-2.
To power IDSM-2 up and down from the switch CLI, follow these steps:
Step 1 Log in to the console.
Step 2 Enter privileged mode:
console> enable
Step 3 Power up IDSM-2:
console> (enable) set module power up module_number
Power down IDSM-2:
Step 4
console> (enable) set module power down module_number

Cisco IOS Software

Once you power off IDSM-2, you must power it up through the switch CLI.
The IDSM-2 CLI reset powerdown command performs a shut down, but does not remove power from
Note
IDSM-2.
To power IDSM-2 up and down from the switch CLI, follow these steps:
Step 1 Log in to the console.
Step 2 Enter configure terminal mode:
router# configure terminal
Step 3 Power up IDSM-2:
router(config)# power enable module module_number
78-16124-01
Catalyst Software, page 7-15
Cisco IOS Software, page 7-15
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Powering IDSM-2 Up and Down
7-15