Removing The 4Fe Card - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Removing and Installing the 4FE Card
You can order IDS-4215 with the 4FE card already installed or you can upgrade IDS-4215 with the 4FE
card to have four additional interfaces. This section describes how to remove and install the 4FE card,
and contains the following topics:
•
•

Removing the 4FE Card

To remove the 4FE card, follow these steps:
Log in to the CLI.
Step 1
Prepare IDS-4215 to be powered off:
Step 2
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
Step 3 Power off IDS-4215.
Step 4 Remove the power cord and other cables from IDS-4215.
Step 5 Place IDS-4215 in an ESD-controlled environment.
For more information, see
Remove the chassis cover.
Step 6
For the procedure, see
Loosen the single captive screw that holds the connecting flange of the 4FE card to the back cover plate.
Step 7
Loosen the two captive screws from the back cover on the left and put the back cover aside.
Step 8
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
3-20
Removing the 4FE Card, page 3-20
Installing the 4FE Card, page 3-22
You can also power down IDS-4215 using IDM.
Working in an ESD Environment, page
Removing the Chassis Cover, page
Chapter 3
1-19.
3-11.
Installing IDS-4215
78-16124-01