Installing the Accessories
Figure 4-9
Step 8
Connect the power cords to their receptacles on the back panel.
Note
Install a tie-wrap through the slot on the strain-relief tab (see
Step 9
Step 10
Bend the power cords back beside the power receptacle housing and form a tight loop. Install the
strain-relief tie-wrap loosely around the looped power cord (see
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
4-24
Installing the Cable-Management Arm
Although the strain-relief can accommodate power cords with a bend radius of up to 19
millimeters (0.75 inch), use only the power cords provided with the appliance.
Chapter 4
Installing IDS-4235 and IDS-4250
Figure 4-10 on page
4-25).
Figure 4-10 on page
4-25).
78-16124-01