Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual page 100

Installing the Accessories
Secure each front center mount bracket (by its nuts and shoulder washers) and tighten them by hand on
Step 5
their opposite slide assemblies using the two shoulder washers and two nuts you removed in Step 2 (see
Figure
Step 6 Join the front brackets you just installed to the bracket on the slide assembly with the two 12-24 x
0.5-inch pan-head Phillips screws you removed in Step 2 (see
The joined bracket becomes the new extended rear bracket.
Figure 4-13
Repeat Steps 4 though 6 to configure the other slide assembly.
Step 7
Holding the left slide assembly into position in the two-post rack at the location you marked, adjust the
Step 8
extended rear bracket tightly against the back of the vertical two-post rack and secure it to the two-post
rail with two 12-24 x 0.5-inch pan-head Phillips screws (see
Secure the front bracket on the slide assembly to the two-post rail with two 12-24 x 0.5-inch pan-head
Step 9
Phillips screws (see
Step 10 Repeat Steps 8 and 9 to install the right slide assembly in the rack.
Use and 11/32-inch wrench or nut driver to fully tighten the nuts on the mounting brackets on both slide
Step 11
assemblies that you tightened with your fingers.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
4-30
4-13).
Rotating the Front-Mounting Bracket for Flush-Mount Installation
Figure 4-14 on page
Chapter 4
Figure
Figure 4-14 on page
4-31).
Installing IDS-4235 and IDS-4250
4-13).
4-31).
78-16124-01